![](/i//PNS_Mounting_1a_small.jpg) |
![](/s.gif) |
1. Peel off small tab.
|
|
![](/i//PNS_Mounting_2a_small.jpg) |
![](/s.gif) |
2. Lay photo over white release paper and push up to gutter.
|
|
![](/i//PNS_Mounting_3a_small.jpg) |
![](/s.gif) |
3. Make sure to cover up the black paper near the gap. There should be about a 1mm gap.
|
|
![](/i//PNS_Mounting_4a_small.jpg) |
![](/s.gif) |
4. Check photo is square on page and gently press photo to the exposed glue.
|
|
![](/i//PNS_Mounting_5a_small.jpg) |
![](/s.gif) |
5. Now that the photo is stuck to the small section of glue, peel off the large outer tab.
|
|
![](/i//PNS_Mounting_6a_small.jpg) |
![](/s.gif) |
6. Smooth out the print from the inner part to the edge to prevent air bubbles.
|
|
![](/i//Summit_Gutter_2_small.jpg) |
![](/s.gif) |
7. The final product should have approximately a 1mm gap, the closest gap in the industry for a peel-n-stick.
|